Surface Probes

Surface probes are manufactured with a flat face on the underside to allow for more stable use on the element being tested. Probes can be purchased in absolute mode and in bridge (SS) or reflection (SSR) configurations. There is a range of frequencies available with all probes being shielded.

*Bridge Config- Triax Connector/ Reflection-4-socket Fischer
**Part Number A-B(inch)-C i.e. SS-0.75-50 is a 19mm 50kHz Bridge Probe (Absolute Shielded)

Featured Standard Probes

US-3716 Surface Scan Probe

The US-3716 is a general-purpose probe that can be utilized in many different surface inspections.  Well balanced differential coils exhibit minimal lift-off signal and can be operated in a broad frequency range.  The coils are directionally sensitive allowing for detection independent of orientation.  It’s a cost-effective method to inspect in-service welds efficiently for near surface cracks and can be used to inspect through thin coatings such as paint.